Back to Learning Centre
    Troubleshooting

    The Top 5 Ways to Stop Boxes Popping Open During Hot Summer Months

    Jul 7, 2023 6 min read

    There may be nothing we can do about the weather warming up. But in this article, we will show the top 5 ways that you can stop your boxes popping open when those temperatures rise. Watch the video below for a quick overview and read on for more detail!

    This embedded video is blocked because it uses cookies that require your consent. Please accept Targeting cookies in our cookie preferences to watch this video.

    Solution 1: Use a Faster Setting Adhesive

    There is a huge diversity of setting speeds across different hot melts and no single solution exists as the application varies. Alphabond have a range of super-fast setting grades designed for fixing this exact problem, with our UltimateCool® 98 being one option we could test in our lab for your factory's application. This glue runs at just 98 degrees as can be seen on the Nordson tank below:

    Nordson tank running at 98°C with UltimateCool adhesive

    Solution 2: Increase Compression Time

    Increase the time that the bond is in compression, either by slowing the line down or if possible, lengthening the compression bars so that the carton or case is not released for a few more seconds, giving the glue more time to set. This is a great way to keep your boxes sealed, but can be an issue for some factories where the speed of production is vital or space is tight.

    Production line compression bars

    Solution 3: Reduce Ambient Temperature

    Reduce the ambient temperature in the immediate area by more efficient heat extraction and/or by using air conditioning. This method is the obvious solution, but can be very expensive especially if you're needing to control the air temperature of large open areas that don't have a system set up already.

    Air conditioning unit for factory temperature control

    Solution 4: Use Less Glue!

    It really could be that simple. If you're able to reduce the amount of glue you're using on each of your boxes, then you should see that the set speed will increase due to there being less residual heat and your boxes won't pop open. This may not work for all applications but it's the most simple method to try.

    Nozzle size versus coat weight comparison

    Solution 5: Drop the Application Temperature

    Experiment with dropping the application temperature of the adhesive by 5–10°C to give the adhesive a head start in cooling/setting. Be wary of overdoing this because if the adhesive is too cool it can lead to stringing or not wetting out.

    Temperature adjustment on hot melt tank

    Hopefully one of these solutions works for you. If you're still experiencing problems or want to discuss switching to a faster setting adhesive, get in touch.

    Need Expert Help?

    Still experiencing pop-opens? Our specialists can test your application in our lab.

    Book a Discovery Session

    Share this article