Introduction
We often hear from packaging technologists who are holding their products in storage for up to 6 months to test the fibre tear that the adhesive provides. They ask us if that is necessary, how long it should take a hot melt sealed pack to have reached its full bond strength, and what can have an impact on this?

In this technical whitepaper, with the support of data from our testing, we'll go through exactly how long it takes a hot melt bond to achieve its maximum strength. We'll also discuss a few things that can affect the time, and what you can do to speed up the process.
The 3 Phases of a Hot Melt
To look at this in depth it is necessary to examine the 3 phases of a conventional hot melt bond forming.
- Liquid phase. This is the initial stage of the bond and where the hot melt adhesive is at its hottest to enable it to be jetted out of the nozzle cleanly and then wet out onto the substrate. This is the upper grey band in the diagram below.
- Plastic phase. As soon as the adhesive leaves the nozzle it starts cooling down. Immediately on contact with the first substrate, it is necessary to bring the second substrate together to wet out on both surfaces and then hold them in compression throughout this phase (shown by the green band). This is the most vulnerable part of the bond formation as any movement of the two substrates relative to each other during this time can cause failed or weak bonds. The time necessary to be held in compression from the substrates being brought together is the set speed and this will vary depending on the adhesive grade used.
- Solid phase. The temperature has been dropping steadily throughout the plastic phase and with this, the viscosity has been increasing exponentially until the adhesive has solidified enough to enable the bond to hold the two substrates together as the product being bonded emerges from compression. This is the solid phase and without mishap, will last throughout the lifecycle of the product.
On a modern packaging line, the whole process is complete in seconds and even with slow setting grades, 95% of the final bond strength will be attained in under 2 minutes with the remaining 5% coming over the next 24 hours.

How Long Does It Take a Hot Melt to Reach Full Bond Strength?
To measure the exact amount of time it takes for the glue to reach a full bond strength, we tested the levels of fibre tear shown when bonds are pulled after increasing lengths of time. The more fibre tear seen, the stronger the bond.
We bonded up substrates and pulled them after 10 seconds, 30 seconds, 45 seconds, 1 minute, 5 minutes, 15 minutes, 1 hour, 6 hours, 1 day, 7 days and 14 days. The table below shows the results we saw from this test:












