Alphabond Field Report
Some Adhesives Only Fail When It's Warm
Most pop-opens get blamed on the line, the operator, or bad luck. This one only happened when the factory got warm.
A tissue paper packer came to us because cases coming off their wraparound case sealer had started springing open, but only in the warmer months. The line had run fine for years in a temperature-controlled area. Once it moved into the main packing hall, the pop-opens started, and they got worse as the ambient temperature climbed.
- Field Report
- Paper & Tissue
- Wraparound Case Packing
- Lantech
- Nordson ProBlue
- Pop-Opens
- PerfectaMax
- UltimateCool
A pop-open with a weather forecast
The adhesive already in use was one of our own cool-running grades, set at a five second compression time. That had already been stretched from seven seconds to try to keep up with production speed, and it was still producing occasional pop-opens. The room itself was reading 28.5°C, warm enough to slow the set time of almost any hot melt past the point where the flaps are held long enough to bond properly.
The instinct here is usually to run the adhesive hotter to compensate. We didn't. Running hotter in a warm room just gives the glue longer to stay liquid, which is the opposite of what a fast-moving case line needs.
Two candidates, tested honestly
We had two possible upgrades in mind, so we trialled both, on their line, on their product, in the same visit.



The first, Perfecta Max 24, is a higher temperature grade. We ran it at 125°C in the tank and up. Pop-opens continued. We tried dropping the temperature to even it out. Still pop-opens. It wasn't the right adhesive for this line, and we said so on the spot rather than persisting with it.
The second, UltimateCool 98 Plus, ran at 105°C in the tank, 25°C cooler than the incumbent. The line ran clean. We pushed it further, cutting compression time down to 3 seconds, faster than the line had run all year. A batch of pop-opens appeared when the board pallet changed, unrelated to the adhesive, and settled again once compression was nudged back up to 4 seconds. Still a full second faster than where the line had been running before the trial, with no pop-opens.
Why we're telling you about the one that didn't work
We could have written this up as a straightforward win and left out the bit where our other product underperformed. That's not how we test things. Half of doing this properly is being willing to say "that one didn't do it" on your own factory floor, in front of your own team, rather than after we've left.
Is your line's pop-open rate tied to the thermometer?
If pop-opens seem to track the weather rather than any obvious fault, that's usually the adhesive's set speed running out of road in a warm room, not a machine problem. We'll bring two or three candidate grades and trial them properly on your line, and tell you honestly which ones don't work as well as the one that does.
Small print: Figures from a genuine Alphabond trial carried out in July 2026. Customer details withheld at our discretion.
Want the same numbers for your line?
One day on your line, with your product and your team watching. We bring the kit, do the maths and leave you the report either way.
Book a free trial on your line